pool start up instructions

If you have drained your pool and are starting with all fresh water please see our. Brush the entire pool surface thoroughly at least twice daily to remove all plaster dust.

Amazon Com Doheny S Ultimate Pool Winterizing And Closing Chemical Kit Master Kit For Pool Up To 35 000 Gallons Patio Lawn Garden

The start-up process is the finishing touch to ensuring a beautiful and long-lasting pool finish.

. If the alkalinity is low add pH. When starting in the spring re-install pool components removed for the winter close drain valves and refit drain plugs. The following recommended start-up method is based on procedures shown to produce the best aesthetic results.

It is recommended that you brush a PTI pool finish three times a day for the first three days and two times a day for the next ten days. Add ounces of Leslies Ultra Brite Advanced directly into the water around the edges of the pool and a small amount directly into the skimmer. Test once a week for the life of the pool.

The following suggestions assume you are starting with water that has been in your pool from prior seasons. Starting on Day 15 test the pool water once a day for the rest of the 28-day startup. Do not add more than 1 quart of acid per day.

Please refer to the attached checklist at the end. Due to unique local water conditions and environmental factors parts of. Wait 4 hours with the circulation system.

Start adjusting your alkalinity between 100 and 160 ppm. 2 Once the Total Alkalinity has been adjusted to 80 PPM and the pH adjusted to. If your pools alkalinity is below 80 ppm you need to add an alkalinity amplifier such as baking soda up to 25 pounds per 10000 gallons of pool water.

And if the alkalinity is above 120 ppm. Important steps to follow when starting up the pool. - Test the pool water more often during the hotter.

Once the pool is full of water start the pool equipment and adjust the calcium hardness until it reaches at least 300 ppm. Using a standard nylon very important. Start-Up Instructions for Chlorinated Pools New Pool Start-Up Instructions.

Again routine brushing is critical to a long-lasting beautiful pool finish. Once that has been accomplished adjust the pH to 72 to 74 the. Record results repeat steps 2 and 3 from Day One.

3rd Day Test pH Alkalinity and. 1 Test the pool water for pH alkalinity calcium hardness. If the alkalinity is high most common add acid.

Recommended Start Up California Pebble Pool Plaster